Juice leaking onto batteries of my ijoy

[3unu(h-80m83r]

This has happened once before but I take my batteries out and there is a little juice on the connections, apparently it's leaking into my mod (ijoy asolo)is this normal? Is it bad?

Sent from my SM-N915V using Tapatalk

 

[Breazy_Com]

It's not normal and it's not good. Anything wet leaking into any electronics can eventually cause a short. What tank or RDA are you using ?

 

[Breazy_Com]

I've been using an Asolo for quite a while now and have not seen that happen

 

[3unu(h-80m83r]

Twisted messes

Sent from my SM-N915V using Tapatalk

 

[Breazy_Com]

OK so it's an RDA. Try not to over juice it. Every once in a while unscrew it and wipe off the bottom of the RDA and the top of the Asolo. Just try to be a little more conscious of letting juice run out or get on it. That goes for any mod, not just this one.

 

[Breazy_Com]

By the way how are you liking your Asolo? I really like the one I'm using.

 

[3unu(h-80m83r]

Ok, got it..... For some reason the center post on my brand new authentic twisted messes was spinning.... I tightened it but I'm thinking to replace the insulators and 510 in it... I'm loving this mod, it seems kinda off to me though because I was running the same build I have now in my ipv4 at 80w but I have to run it way higher in this mod, more around 120w... Have you had that issue? Also I love the taste control, but I love my dual alien wire set up more hehe wish it could regulate below .15 but I get it, quite a new technology

Sent from my SM-N915V using Tapatalk

 

[Breazy_Com]

Yes it does seem like you have to run this higher than the IPV4 or 4S. That's because the IPV series runs about ten percent higher than your actually setting it for. I was trying another mod recently and I had to go way higher with that than both the Asolo and the IPV. That box seemed underpowered.

 

[3unu(h-80m83r]

Huh... And the battery doesnt cut off half way or so like on the ipv. Do you know if its pulling on them when they get really low... Should I be taking them out half way? What kind of build are you running?

Sent from my SM-N915V using Tapatalk

 

[Breazy_Com]

I used an RDA on it for a while now I just use a tank with a nickel coil. I haven't run the batteries down more than halfway so I can't answer the other half of the question.

 

[f1r3b1rd]

This has happened once before but I take my batteries out and there is a little juice on the connections, apparently it's leaking into my mod (ijoy asolo)is this normal? Is it bad?

Sent from my SM-N915V using Tapatalk

The battery door is at the bottom of that mod, correct?
Trying to see if your 510 is leaking or maybe a space between the top plate and sidewall of the mod?

 

[3unu(h-80m83r]

It was getting on the two upper connections, by the atomizer... Im really thinking it's the outer walls because there was no juice in the 510 hasn't happened since I've been careful about the amount of juice I put in my rda

Sent from my SM-N915V using Tapatalk

 

[f1r3b1rd]

Hmmm, be careful, bro. What I'm wondering though is if thick ejuice is getting into the mod then what happens if it rains or a tank leaks.

Is there a gap under the top part of the box? Forgive me, I've not seen one of those in real life, and if I remember correctly the top is one piece and the body is another, which would create a seem. if you hold it to the light is it sealed up at that seem?

 

[3unu(h-80m83r]

Trust me, I have been it's possible there is a gap... Doesn't really seem like it. Can't see if there's light. It's a pretty well built box. I might go in and tighten the screws just in case

Sent from my SM-N915V using Tapatalk

 

[3unu(h-80m83r]

Also, it's was like 2 drops... Not flooded

Sent from my SM-N915V using Tapatalk

 

[f1r3b1rd]

Roger that, just be safe dude!
I was just thinking warranty wise is all.

 

[3unu(h-80m83r]

Yeah it's 2 pieces, I'll keep an eye on it.... Dont really have to change much, just put less juice in my atty seems to have been working

Sent from my SM-N915V using Tapatalk

 

[Whiskey]

Thread moved to VV mod section