No clue where to post this. Searching for a LH contact pin

[Tornadoalleydeb]

Been searching for several days now with no luck at all. I have a SXK Zero V3 mod. The 510 copper contact pin broke off inside. I bought it used and I swear that pin was seized up in there. Anyway, when I was trying to raise it up it stuck and then just snapped off. It is a LH ( reverse thread ) screw. I finally got it out of there but I can not find anything anywhere that will work. The new REO 510 screw is a LH and it is the correct width but just a little short. the REO 510 looks to be 2x2mm I probably need a 2x3 heck it could be longer, as I could dremel it down. Does any one have any idea where I can find a screw for this thing? I truly like the mod and It bites that I can't use it Thanks so very much in advance for any info.

 

[skiball]

Might just be easier to put on a new 510 http://www.varitube.com/510-Connect...n--14mm-22mm-285mm-Smooth-Top-22mm_p_141.html

Sent from my HTC One X using Tapatalk

 

[Tornadoalleydeb]

Thanks. The way this one was made, I would have to take it all apart, pull the chip out and everything. I'm not nearly handy enough to do this.

 

[skiball]

Thanks. The way this one was made, I would have to take it all apart, pull the chip out and everything. I'm not nearly handy enough to do this.

Right on well you did state your good with a drimel could prob find the reg size screw your looking for cut off the head and put a notch in the back for your screwdriver and if that dont work id just jam w/e u can fit in there and get a heatsink lol

 

[Tornadoalleydeb]

LOL ya, I may have to do that. I have a few folks looking for me. One way or another I am going to make this work! Thanks for your suggestions and help

 

[HAZZA1962]

I got a spare 510 screw with mine!!!

 

[Whiskey]

Putting this in VV mod section

 

[Tornadoalleydeb]

I got a spare 510 screw with mine!!!

Lucky you I guess

 

[HAZZA1962]

Mine was tucked under the foam insert in the box in a tiny plastic bag!!!

 

[Tornadoalleydeb]

aaah I see. Unfortunately I bought this one used and I already talked to the seller and he does not have it. I will figure something out.

 

[dre]

You could make it a fixed pin by finding the right size copper or brass nail and cutting it to length if the hole bottoms out. As long as your not using this in tc it will be fine.

from Tapatalk

 

[BoomStick]

Check fatdaddyvapes.com