Become a Patron!

lid

  1. bigash000

    Wismec RX 2/3 - the lid no longer closes the circuit

    Hello! It is my first time posting so if there's a better category for this issue, plese let me know. My Wismec suddenly is no longer working after fixing the lid in place. It does however work if I put the lid slightly below, so that the metal connectors touch eachother in a specific way. Any...
  2. scvette

    HexOhm Minion cover lid in cold cast copper

    I recently 3d printed a 'carbonite minion' from Thingiverse on my Titan 1 DLP resin printer then hot-melt glued it to my HexOhm cover. Next, I molded the adorned cover in a two part silicone mold for resin casting. Once the silicone set, I brushed fine grain copper powder on the the face of the...

VU Sponsors

Top