.1 (ish) ohm builds?

[kennykoils]

Title says it all, I'm picking up an invader 2 tomorrow and I'm looking for help with some .1-.15 ohm coils, prefer a quick ramp up. And yes. I know it's low, but the amp load will be split between 2 vtc4, so about 21 amps a piece gives me plenty of headroom. That being said, looking for ideas for some low ohm builds, will most likely be done on my troll mod. I usually build with 24 kanthal and or 26 ni80 on my mech but have access to a lot of wire just want some solid base/opinions for my first build in it tomorrow night I tried one out today with my build from my mech, parallel 24ka/26ni80 on a 3 mm bar around .17 ohm and it kicked ass but I want to go real low an get the most from my new box. Thanks in advance folks!

 

[itsmenotyou]

fused claptons using 24 for the cores and the smallest outer wire you can. 5 wraps on a 3mm bit should ohm out to about .15ish simple and flavorfull

 

[zaroba]

My normal build is dual 20 gauge kanthal, 4.5 - 6.5 wraps. 0.12 - 0.14 ohms.

I use regulated though, not a mech, so can get a few second ramp up time if they are cold depending on wattage.
But after that there is no noticeable ramp up unless I wait 30 seconds between hits.

 

[kennykoils]

fused claptons using 24 for the cores and the smallest outer wire you can. 5 wraps on a 3mm bit should ohm out to about .15ish simple and flavorfull

I've got a pair of fused claptons with 26ni80 core and 30ka over it but the outer wrap is too thick takes more than I like to heat up, they're around .15 if I remember correctly, like to do it with 34 or 36

 

[ej1024]

22g NICHROME 4/5 wraps 2.5 diameter .13-.14ohms if u want quick ramp time, THIS....


VAPE ON

 

[kennykoils]

22g NICHROME 4/5 wraps 2.5 diameter .13-.14ohms if u want quick ramp time, THIS....


VAPE ON

I don't think it would have the surface area to chuck? Maybe duals at like 9-10 wraps around a 2.5 pretty sure the lowest gauge ni80 at the shop I frequent is 24

 

[ej1024]

I don't think it would have the surface area to chuck? Maybe duals at like 9-10 wraps around a 2.5 pretty sure the lowest gauge ni80 at the shop I frequent is 24

I thought you said you want quick ramping time?


VAPE ON

 

[kennykoils]

I thought you said you want quick ramping time?


VAPE ON

By quick I mean half a second or a second, don't need it like a light switch haha