Become a Patron!

5 tips from an Ecig player to all those new to mech mods.

Urvapin

VU Vendor
VU Vendor
Silver Contributor
Member For 4 Years
vaping-tip.jpg

First, the new player should avoid using the mech mods with no protective chip. He or she can have a try after having a full knowledge of how to make atomizer chip, basic electronics Information, security and protection knowledge.


Second, the finished atomizer and the atomizer of no protruding electrode must not match with the mech mods.


Third, when using the mech mod, the battery (unusable if the skin is broken or out of shape), atomizer (if the screw of the electrode is fastened, if the coil position is short-circuit ) and the mech mod (if there is any stain of liquid or connection of contact)


Fourth, use the battery of standard brands. Don’t buy batteries indiscriminately. Calculating according to ohm law to decide how many batteries should be used. If the positive electrode or negative electrode is of broken skin, don’t use it. The battery used for box mod may not drive the mech mod. PVC can get peeled easily. Peeling can also be dangerous.


Fifth, don’t use replicas mod of poor quality. Some models of the replicas mods have problems, resulting that the bottom cannot bounce back. Moreover, the bottom of the atomizer should not be of oil. When there are problems caused by taking petty profits, such as abnormal heating when using, or no vapor when igniting, the user should dissemble the battery to check. If it’s too late, the user should throw it to a place where is no people around and warn people to keep away from it.


Super Deal Link: www.urvapin.com
 

r055co

VU Donator
Platinum Contributor
Member For 4 Years
You're missing a lot of very important information. Here's what I give to those thinking about getting into Mech's.

1.Ohm's law, http://www.steam-engine.org/ makes it easy and there's even an app on it for Android

2.Batteries, take good care of your batteries and know them!!!!!!!

a.Avoid shit batteries like eFest who rewrap rejects with grossly inflated amp ratings. Stick with authentic LG, Sony or Samsung from reputable (not eBay or Amazon) sources, great places that I get Authentic batteries from are -

http://liionwholesale.com/

https://www.imrbatteries.com/

b.Stick well within Continuous Discharge Rate (CDR) Not the "pulse"

c.Keep up to date with what Mooch tests and battery ratings, follow his posts on Facebook and his Blog and only use his recommend batteries.

d.In Mod's with multiple batteries, marry them.

e.Get some battery wraps, they're cheap and easy to re-wrap batteries. Any nicks,tears or what ever don't be stupid and just re-wrap.

3.Don't build stupid low a good builder can chuck and get awesome dense vape from a good build. It's simple, with 20 CDR Amp batteries -

a.Single battery mod's you're fine with .2 ohms on up

b.Dual Parallel you're fine with .15 on up. Parallel you take the full CDR of one battery then add 1/2 the CDR of the next battery

c.Series you double the voltage but you share the amps . So a series you build high with a lot of wire mass no lower that .4 ohms.

4.Make sure you don't have any shorts. For an extra caution any new build I will vape on a regulated mod for a few drips or with a tank about a 1/4 tank. This is to insure nothing wonky with my build like shorts.

5.Careful if it's not in your hand, if it doesn't have a lock on the button and you put it in your pocket (which I really don't recommend) insure nothing else is in your pocket and it's loose. Don't want to put it in your front pocket and blow your dick off ya know ;)

6.Last but certainly NOT the least, keep it clean! Clean it when you first get it "before" you even use it and clean it on a regular basis.

a.Ultrasonics are a very good investment, got mine off Amazon for around $25.

Sent from my Nexus 6 using Tapatalk
 

VU Sponsors

Top