Become a Patron!

Am I safe with this setup?

Hello!
I'm (kinda) new to vaping, only used a starter pack for a while and now I'm considering to buy something a little better. Basically I cannot tell/calculate if this combo below is reasonable or most importantly safe, so maybe you guys can give some advice? Thanks!

http://en.finnvape.com/product/1132/lg-he4-18650-2500mah-battery-1-pcs
http://en.finnvape.com/product/833/ea-mod-b
http://en.finnvape.com/product/1157/smok-gct

The info on those product pages are pretty much everything I can find online.
 
Yeah, the setup is safe but it depends on what kind of coil you put in the tank that will make the difference.

OK, thanks. The clearo comes with 0.2 ohm coil for 20-80W and the battery's output is 20A / 35A max (75 s). Don't want it to explode on my face :D
 

Pauly Walnuts

Gold Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Just be careful using pre built coils on a mech. The reason is, with prebuilt coils, your only a cracked piece of rubber away from a short. Its rare that they come broken, but it can happen.
So I would suggest you buy an ohm meter too, to check each new coil.

FYI .2ohm at your battery's max charge (4.2volts) is going to run 21amps, which is 1 amp higher than your battery's continuous rating.
This is something Ive personally never worried about. I used to run .2ohm builds with 20amp battery's all the time, with no problems.
Just remember, awareness increases safety. Keep close tabs on the temp of your mod.
As long as your not chain vapin like a freakin chimney you should be fine with this set up.
 

madmonkey

The Road Warrior
VU Donator
Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
I'd personally would not use that tank with a mech mod...it says that it comes with Nickel wire coils which are meant to be used with regulated devices that have temperature sensing functions like the DNA 40D board and such. If you're going to go the mech route with a sub ohm tank like that I would shop a little more and find one that uses coils made of more conventional wire like Kanthal or Nicrome for safety's sake
 

VU Sponsors

Top