Big problem! My Obs Engine is stuck !!!!!

[goyetus]

Im really upset, dont know what to do.

My obs Engine Metal frame is stuck into the deck base as you can see in this photo.
If I try to get out clockside, I start to bend the frame........

Any suggestion?

Thanks!!!

 

[all_thumbs]

Put it in the freezer, or heat it up with hot water or both in succession.

 

[goyetus]

Thanks I will try it!

 

[BoomStick]

Apply an ice cube to the part with the male threads for 10 seconds.

 

[all_thumbs]

Also get one of those tank wrench/ceramic tweezer combos if you don't already have one. Mine has been very good at preventing me from throwing a stuck tank through a window!

 

[errevi]

Put it in the freezer some minutes

 

[UncleMike]

Clockwise would tighten it no? Righty tighty , lefty loosy

 

[goyetus]

Solved !!!! With a screedriver doing some preasure upside, and a rubber tweezer!!!
Thanks a lot to all!!

 

[hockplayer11]

Solved !!!! With a screedriver doing some preasure upside, and a rubber tweezer!!!
Thanks a lot to all!!

Can you tell ne exactly what you did bc I have the exact same problem

 

[Zohmbiebuilds]

Lots of trouble with the pharoah I have been hearing. Too bad. I've heard good to, but this seems like the main problem there having. I'm wondering if it's a batch and can be solved, user error, over tightening, or a bit of all three.

I want to get the drop but if there sloppy threads I will pass

Sent from my Z981 using Tapatalk

 

[hockplayer11]

Ya I finally got it the threads were just messed up and it was really tight but now it's fine