Built my rda yesterday but still burnt

[The Shake]

I purchased this rda and did my first build on it yesterday. In the beginning it worked fine, its a .129 ohm build and I was running it at about 85 watts. As the day progressed though the flavor continued to get worse and a burnt flavor started to reveal itself, now if I take any hit longer than 1 second on 70 watts the flavor comes out burned. Any idea what I did wrong here?

 

[SteelDriver]

Rewick burn gunk off run lower watts. Or tc if you can.

Sent from my SAMSUNG-SM-N910A using Tapatalk

 

[The Shake]

I would love to try tc but I have no prior experience with it, this is my first non tank mod so most of this is new to me. Is there a resource where I could learn the ropes on what temp is so as compared to wattages?

 

[SteelDriver]

Google or you tube. What is your mod and do you have some ss wire

Sent from my SAMSUNG-SM-N910A using Tapatalk

 

[The Shake]

Google or you tube. What is your mod and do you have some ss wire

Sent from my SAMSUNG-SM-N910A using Tapatalk

I have an alien 220w box and no I do not currently have any SS wire, but I could go pick some up later this week if necessary.

 

[SteelDriver]

You need it for tc. Google and do some research it's not hard and it makes dripping on rda alot easier to avoid dry hits. It basically means you set temp you like and mod only uses enough watts to achieve that temp thus avoiding burning wick. I personally and alot others use ss 316l. 316l will also work in Wattage so it is versatile.

Sent from my SAMSUNG-SM-N910A using Tapatalk

 

[The Shake]

You need it for tc. Google and do some research it's not hard and it makes dripping on rda alot easier to avoid dry hits. It basically means you set temp you like and mod only uses enough watts to achieve that temp thus avoiding burning wick.

Sent from my SAMSUNG-SM-N910A using Tapatalk

Okay thanks for all the help

 

[The Shake]

Sorry for the delayed update but just wanted to tell you that your advice worked flawlessly. I dry fired the coils and rewicked, ran it at about 60 watts with no issues. I slowly upped the wattage and am now running at 75 with no issues. Thanks for all the help, I will also look in tc and picking up some ss wire later this week!

You need it for tc. Google and do some research it's not hard and it makes dripping on rda alot easier to avoid dry hits. It basically means you set temp you like and mod only uses enough watts to achieve that temp thus avoiding burning wick. I personally and alot others use ss 316l. 316l will also work in Wattage so it is versatile.

Sent from my SAMSUNG-SM-N910A using Tapatalk