Cloupor mini battery question

[Bean8379]

I have a 10A 3100mah battery that I think will be OK because the max output current of the mod is 10A and I won't be getting anywhere near 10A anyway. The main issue is, its a button top. I've measured it, and the length is 2&5/8". Can anyone tell me if it is too long of a battery for the mini?

 

[CorallineAlgae]

It might be a tight squeeze but it should fit. The bottom negative contact on the Cloupor mini has a lot of give. It uses a sort of leaf spring. Shouldn't be a problem.

 

[Bean8379]

Thanks for the reply! That's good to know, I was really hoping to run my 1600mah in my mech and my 3100mah in my mini. Now I know that it should work!

 

[Powerman]

My orbtronics didn't fit. It's really tight.

 

[Bean8379]

It might be a tight squeeze but it should fit. The bottom negative contact on the Cloupor mini has a lot of give. It uses a sort of leaf spring. Shouldn't be a problem.

Is there a way you could measure the battery compartment on the mini so I know for sure?

 

[Powerman]

I don't have them anymore. I used Sony VT5s. They were tight. There isn't a lot of room. If a button top fits, it's small.

 

[Bean8379]

Thanks but I was actually asking coralline if she could measure the mini's battery clip.

 

[CorallineAlgae]

The battery compartment has a leaf spring that bends. It's not possible to measure the flex of the spring. Otherwise I get right at 2 & 9/16".

 

[Bean8379]

Then this button top I have will definitely fit. Thanks again!