I recently purchased an eleaf iJust 3 and have been using the supplied HW-N .15ohm coil. I've primed the coil, per eleaf's instructions, but am continuously getting dry hits on the 3 or 4th puff- I'm not chain vaping either, nor am I using it in any other way that's incompatible with the device. Granted, my knowledge is limited because I am new to vaping, however, one thing I noticed about these coils is that when you look through the side holes, you can see exposed cotton through only one of the holes (there are 6 total)- when I look through the remaining 5 holes, I see more stainless steel. If I turn it at an angle, I can just barely see the edge of exposed cotton- but nothing lines up with the holes on the actual coil housing. I've noticed that it's the same with every coil in the pack I purchased, which leads me to believe that this design was intentional. The reason I mention this is because the coils I've used in the past, I was able to see exposed cotton through each of the side holes. For what it's worth, I haven't tried the HW-M .2ohm coil (came with the set) yet. Also, for what it's worth, I am using Naked Lava Flow .3mg 70/30. I've even tried dropping juice onto the metal mesh on the inside of the atomizer itself, in addition to the side holes (remember, they don't line up, as mentioned above) and the cotton itself. Lastly, I disassembled a coil that had been acting up- dry hits- took the cotton out, etc. and everything was completely saturated- no dry spots, no burnt spots, etc. So with the exception of not trying the HW-M .2ohm coil yet, I'm not sure what else to do???
