Hammer of God V3 adjustable pin issue?

.




Hi there,

I recently puchased a brand new Hammer of God V3. When I use it with the Recurve Rda it's firing instantly without any issues.

If I put the Aromamizer Titan on top it doesn't fire at all.
Though I can unscrew the 510 pin connector on the Titan however the screw would be loose, sitting between the insulator.
Would it be possible or even better to unscrew/adjust the 510 pin on the HoG V3?
Although is the 510 pin on the HoG V3 fixed or should it be a flexible spring type?

It's very strange since I never had any connectivity issues on mech mods. Connector pins were always very tight on all gear...

Many thanks in advance!
 

Carambrda

Gold Contributor
Member For 3 Years
ECF Refugee
Don't loosen up the 510 center pin on any RBA, and especially don't do it when you're using it on a mech mod. The 510 pin of he HOG V3 is adjustable (with a flat head screwdriver).
 
Ok will do so.

However what's the background of this? Is there any advantage in adjusting the 510 pin of the HoG V3 instead of the RBA?
 

Guyando115

Bronze Contributor
Member For 1 Year
Ok will do so.

However what's the background of this? Is there any advantage in adjusting the 510 pin of the HoG V3 instead of the RBA?
The 510 on an rda, rta should always be screwed on tight. The 510 on the hog is just adjustable rather than spring loaded. 1 thing i found with my trinity though is over time, when changing rda's, the 510 will start sinking into the hog. I fixed this by placing a tiny grommet around the 510 pin underneath the hogs top plate. Problem solved.
 

VU Sponsors

Top