I'm running a Kanger TopTank Mini on an IPV D2...
When i bought it... i had the man behind the counter setup the coil and wick for the RBA that came with the KangerTech TopTank Mini..... i eventually swapped out to the small 0.14ohm resistance SSOCC and then the slightly larger SSOCC (With the red o-rings) since i tried to coil it myself and my mod displayed the error "LOW RES"
I always get problems with leaking...
It leaks out the top cap and around the airflow holes (Not exactly the holes but the thin slit above the airflow adjustment ring)
And it only leaks when i fire it up for a few hits
and i'm also finding it very hard to clean out my tank...
I dissassemble everything...
and i scrub it with my fingers under the tap
and towel dry it...
Somehow it still smells of the liquid i placed in it...
Is there a good way to clean the whole tank?? (including the RBA coil)
and is the leakage a problem of the tank itself?? or is it user error??
I'm also a beginner at wicking and coiling
Please help and be gentle since i'm new to vaping..
In the image below.. i've highlighted the thin slits where leaking occurs after a few hits..
When i bought it... i had the man behind the counter setup the coil and wick for the RBA that came with the KangerTech TopTank Mini..... i eventually swapped out to the small 0.14ohm resistance SSOCC and then the slightly larger SSOCC (With the red o-rings) since i tried to coil it myself and my mod displayed the error "LOW RES"
I always get problems with leaking...
It leaks out the top cap and around the airflow holes (Not exactly the holes but the thin slit above the airflow adjustment ring)
And it only leaks when i fire it up for a few hits
and i'm also finding it very hard to clean out my tank...
I dissassemble everything...
and i scrub it with my fingers under the tap
and towel dry it...
Somehow it still smells of the liquid i placed in it...
Is there a good way to clean the whole tank?? (including the RBA coil)
and is the leakage a problem of the tank itself?? or is it user error??
I'm also a beginner at wicking and coiling
Please help and be gentle since i'm new to vaping..
In the image below.. i've highlighted the thin slits where leaking occurs after a few hits..
Last edited: