Become a Patron!
Hohm Tech Skillet
- Thread starter BrewBear
- Start date
Pay attention to your coils!!!!
I decided I wanted to do a little tootle puffin this afternoon so I grabbed the skillet and installed a new coil. As I was priming the coil I noticed something odd looking on the top, inside of the coil. I stuck my my bottle tip in and pulled this out! Really would've suck to swallow this or worse sucked that shit into my lungs!
Pay attention to your coils, please.
Did you mean to attach a pic? Curious to see what "this" was.
EDIT: haha sorry, posted at the same time.
Post 301 has it. That would be bad to inhale indeed
Sent from my SM-G935V using Tapatalk
Sent from my SM-G935V using Tapatalk
Hey, for the people using Kayfun and other RTAs on their Skillets, what happens with the "hard" and "soft" "modes" this device had, depending on what ohm you're using? Has anyone experimented with different ohm builds to see when these different "modes" kick in?
Yeah
And it's not as big of a deal, but also check the ohm markings on the coils from the packs you've bought. One of my 5 packs of .5 coils has a 1.0 coil in there. Kind of annoying, since my customers pretty much universally prefer the .5s.
Oh really? I don't think any of my customers have used a 1.0 long enough to get a sense of the lifespan. lol
My issue is that Hohm Tech went a little too far in the "soft" direction with their "soft" mode for higher ohm coils on the Skillet. It's a pretty slow ramp up when using the 1.0 coils, slower than most people are going to enjoy.
Call it stubbornness or patience on my part but I vaped the 1 ohm's until they failed.Failure rate was 3 days across the board.Less than half the life of the 0.5 ohm coils which last around a week.
