Installing a dual coil

[shawnw1561]

I'm not very new to vaping, I've been using RDA's for a while now, but always running single coils. I'm starting to get into the dual coil setups, but keep running into an issue. Specifically, once I've installed the first coil, and go to the second, I cannot seem to get it installed and clip the leads without messing up the first coil. I've tried keeping the leads short, but have trouble installing it if they are too short, and cannot seem to get anything behind the first coil to clip the leads of the second.
Any suggestions from the RDA masters?

Sent from my SCH-S968C using Tapatalk

 

[thefogmachine]

You need a pair of ud diagonal pliers it will make your life ten times easier until u get those I'd recommend snipping your leads then removing the first coil install the second coil snip your leads then put the other one back in

Sent from my XT1080 using Tapatalk

 

[BigNasty]

It can be frustrating.
If you want to just say piss on it pick up a velocity or phenotype.

 

[scarecrowjenkins]

Lay the second coil over the tops of the posts to see how long the leads need to be, then clip em and slide em right in

 

[Neunerball]

What RDA are you using?
You don't have to position the first coil, until you put in the second. So, you can even bend the first coil up/down, out of the way, in order to get the second coil in. Once you got both coils in, you position the coils.

 

[shawnw1561]

I'm using the mutation X V4 at the moment. And I'm not sure why I never thought of just taking the first coil out to put in the second one..
Now it seems too simple. Haha

Sent from my SCH-S968C using Tapatalk