Become a Patron!
Interesting new MOD - Think wismec reuleaux rx200 -but with Yihi SX340
- Thread starter TechnoGeek
- Start date
Kangside has made some ok stuff and some duds. I have a Kangside vaporflask clone that is 50W, temp control and works great. I also have a Kangside squonker which is a piece of shit.
It will be interesting, Have not found any info on the SX340 board.
Edit: the Kangside site says it's a SX345 Board by YiHi. YiHi does not have a listing for a SX345.
It will be interesting, Have not found any info on the SX340 board.
Edit: the Kangside site says it's a SX345 Board by YiHi. YiHi does not have a listing for a SX345.
Last edited:
I think it is the same board that is in the ipv5. Either possibly mislabeled or an upgrade, but the upgrade is less likely since Yihi does not list a sx340 board on their site.
This listing for the ipv5 says it has the latest sx340 board, but in the bullet point list below it says the sx330-200.
https://www.elementvape.com/pioneer4you-ipv5-200w-tc-temp-control-box-mod?enter=true
Speaking of ipv I just seen this on their site when I was looking at board specs.
http://www.vapingbest.com/ipv400-200-watt-box-mod-by-pioneer4you-p-548
To be honest, I don't see the point. It cost more than an RX200, it's larger than the RX200, and has less features (lower power limits in TC, and no SS mode, really?), and the fact there's no ventilation is a No-No.
It would seem that Kangside is just a cheap "cloning" company, as you can see all their mods are poor copies, or should I say they were "inspired" by other mods by well known manufacturers. They have a version of the Reuleaux, the Sig100, the IPV4, the IPV D2, the Hohm Wrecker, iSticks, etc. All of their mods look inferior to their "sister" mods, and end up lacking features too.
So the fact that it's lacking safety features, firmware features, is of inferior quality materials, and costs more than the original......................that's a big ole "NOPE" from me.
It would seem that Kangside is just a cheap "cloning" company, as you can see all their mods are poor copies, or should I say they were "inspired" by other mods by well known manufacturers. They have a version of the Reuleaux, the Sig100, the IPV4, the IPV D2, the Hohm Wrecker, iSticks, etc. All of their mods look inferior to their "sister" mods, and end up lacking features too.
So the fact that it's lacking safety features, firmware features, is of inferior quality materials, and costs more than the original......................that's a big ole "NOPE" from me.
Last edited: