Jules Setting in TC Mode on a IPV 6X

[ChrisL]

I got a sweet deal on an P4U IPV 6X, and I was wondering what would be a good Jules setting if I wanted to vape nickel or SS in TC mode at around 460-480F? This will be my first device with a Yihi chip, so not up to speed on jules yet.

 

[Jim_MDP]

I got a sweet deal on an P4U IPV 6X, and I was wondering what would be a good Jules setting if I wanted to vape nickel or SS in TC mode at around 460-480F? This will be my first device with a Yihi chip, so not up to speed on jules yet.

For our purposes... Joules are identical and interchangeable with Watts.
For some reason (legal considerations with Evolv using Watts perhaps) P4Y decided to use Joules for their interface... as far as I know, no one else cares.

I personally don't vape that hot as a rule, usually around 420F, give or take depending on the build (and if I've been too lazy, again, to rewick ) but of more import... you don't mention a resistance or range, or what type of coil. An exotic, heavy metal build (Claptons and beyond) will require more power than a simple coil for a satisfactorily short ramp-up time.

You can't go wrong starting low and working your way up to what works best for you... gives the coil and wick a chance to "break-in" as well. But generally... I can expect to work up to about 30-35 watts or so with simple 0.5 ohm coils, more or less depending. And proportionally more with a coil built to a lower resistance. Just ballpark starting points though... some simple 0.5's may easily take 45 Watts. Dual coils even more.

And then... more wattage for TC, as the mod will use it for ramp-up control then back off as it hits set temp.

Simple eh?


eta: Sorry... distracted and posting (at least I'm not drunk )
Should have noted your join date and post count... you probably know most everything I wrote.
Just ignore everything but the first graph. I'll leave the rest in place in case it helps someone else.

 

[jbone6977]

I wouldnt expect much out of the 6X tc wise with SS, its pretty shitty no matter where you set it, I bought it for portability and power and love it for that. Iv run 316L in TC on it, changed settings up and down and it was never remotely close to good so switched back to power mode. No complaints from me, its a good, portable, inexpensive non updateable dual 18650 mod that is great in power mode. If you are expecting more than that then you will be disappointed

 

[ChrisL]

Thanks guys. At $37.00 with free shipping, it was an impulse buy. The reviews on youtube were positive, so Ill just give it a try and see. I have a ton of nickel coils for my old Crown V1's and Herk V1's, just wanted to use 'em up as lm slowly going back to power mode vaping with newer tanks and RDA's.

 

[skt239]

Thanks guys. At $37.00 with free shipping, it was an impulse buy. The reviews on youtube were positive, so Ill just give it a try and see. I have a ton of nickel coils for my old Crown V1's and Herk V1's, just wanted to use 'em up as lm slowly going back to power mode vaping with newer tanks and RDA's.

There are three versions of the 6x and the last one will do TC in SS. Check out DJLSB vapes review