Kangertech subtank mini Coil Builds

[m0rg0o7]

Hi im wondering what the best coil build people suggest for the subtank mini rba. iv got 22 gauge kanthal and got 5 raps and getting 0.3 Ohms. Was wondering what other people use for this setup?

 

[Nailz]

I use 26 gauge kanthal 5/6 wraps coming out between 0.60-0.70 ohms.

Also been trying nickel, but hit or miss if a good build or not, thinking I might try some titanium next.

 

[m0rg0o7]

ye im finding that the 22 gauge 5 raps is right on the limit of .2 to .3 ohms and it wont fire at 0.2.

 

[AmandaD]

How do you even get 22 gauge under those screws?

26 gauge Ti, 3mm spaced, 5 wraps for .26. I tried 24 Ti and couldn't get the wire properly trapped for a good connection for TC.

 

[m0rg0o7]

kind of take the screw till there pretty much fully out then get the coil positioned and off i go . Would be a lot easier with small gauge lol, but for the moment its not to bad.

 

[m0rg0o7]

I also find it spits a lot so time with the rda on you guy experienced that ? No any fixes

 

[AmandaD]

No spitting - maybe more wick? I find the stm needs very heavy wicking.

 

[Emberwilde]

I run a 4 strand twisted 32g ni200 7 wraps 2mm ID, comes in around 0.051-0.055

 

[m0rg0o7]

wow thats low lol and Amanda ill re-wick with a bit more and see how it goes, thanks for the advice

 

[Emberwilde]

it is low, but it is TC on nickle..... I find on a single coil the twisted adds some tonnage to the vapor

 

[m0rg0o7]

sounds awesome, im not at the stage of twisted coils yet lol just about getting standard ones right lol

 

[m0rg0o7]

finally got some .26 gauge and it is a lot better and much easier to work with the kanger subtank. fire at around .8 ohms . cheers for all the advice guys