Koopor Plus not working with Crown Ni200 coil

[cmoorewv]

I switched my crown tank to the Koopor Plus mod be a use my evic mini was running low on battery. It has the Ni200 TC coil in it for now. It worked just fine in the evic mini, but the Koopor Plus is having fits. First, it's not reading the resistance properly at all. It's a 0.15 coil. The Koopor will read it at over .3. Then it asks new coil or same coil. I'll tell it new, it fires once, maybe and then flashes the check atomizer message. This happened repeatedly. It's in Ni TC mode. I finally gave up and put my Smok vct on in watt mode and it's working just fine. I'll check the connection between the tank and mod (if I try the crown again ) but I'm pretty sure it was ok. Could it just be that the Koopor just doesn't like that coil? It worked great in watt or TC mode with the .25 and .5 SS coils.

 

[BPROSEK]

I switched my crown tank to the Koopor Plus mod be a use my evic mini was running low on battery. It has the Ni200 TC coil in it for now. It worked just fine in the evic mini, but the Koopor Plus is having fits. First, it's not reading the resistance properly at all. It's a 0.15 coil. The Koopor will read it at over .3. Then it asks new coil or same coil. I'll tell it new, it fires once, maybe and then flashes the check atomizer message. This happened repeatedly. It's in Ni TC mode. I finally gave up and put my Smok vct on in watt mode and it's working just fine. I'll check the connection between the tank and mod (if I try the crown again ) but I'm pretty sure it was ok. Could it just be that the Koopor just doesn't like that coil? It worked great in watt or TC mode with the .25 and .5 SS coils.

I have used my crown with ni200 coil on my koopor plus without any issues. Did you try going into the menu and manually setting the resistance for the coil? Maybe that might help?

 

[CorallineAlgae]

Try giving the 510 connection on the tank and mod a good cleaning with alcohol and a Q-tip. I've had the same thing happen to me a few times on other mods and that solved it most of the time. Couldn't hurt, even if it doesn't work.

 

[cmoorewv]

Seems to be working for now, but it's still reading a bit high

 

[cmoorewv]

And there it went again. It may be in the connection because the resistance reading goes to .00, like it can't tell anything is there. Funny that it hadn't done that with the SS coils. I think I prefer them over the Ni200 anyway.

 

[cmoorewv]

IDK-I took the entire tank apart, cleaned it, took out the coil and put it back in and screwed everything back together. The bottom part that unscrews to change the coil was practically glued together. In any case, the mod read the resistance at .18, so I adjusted it to .15 and hopefully it works. Prior to all that it wouldn't read the coil below. 24
I did double check that it is, in fact, an Ni200 coil. My 40+ year old eyes don't read fine print easily anymore. LOL.