Lemo 2 reading 0.0 ohms- why oh why????

[Kay_Fun!]

I purchased the Lemo 2 and was using the stock .5 ohm coil for a day, when suddenly it would not fire. Checked my mod (iPV mini 2) and it said "check atomizer" and it read 0 ohms. Put it on an stick 30, same thing. Rebuilt the coil to .9 ohms on my ohm meter, but damn if my mod still can't read it. Suggestions?

 

[Zamazam]

I'd check the positive 510 screw on the 510. Take the bottom airflow part with the 510 connector off. There is a slot screw when you take it off. Back out the slot screw 1/2 turn and put the bottom part back on and test.

Almost forgot - re-tighten the screws holding the coil in place, make sure there are no shorts with the coil legs.

 

[Kay_Fun!]

ok- how do I take the bottom airflow part off? Do you have a pic or video link?

 

[Zamazam]

Hold the fluted bottom part that the tank is fit into, then grasp the lower section with the airflow slot and turn counter clockwise. It should come off easily.

 

[Kay_Fun!]

You are the bomb! Thank you for your help! Spock was always my favorite...

 

[Kay_Fun!]

I did your fix but this atty is still wanky. Is anyone else having issues? I got this to use with temp control but now I don't trust it.