Mod problem

[immykhan]

How can 1 know if there is a problem with ure mod or tank?

Sent from my ONEPLUS A3003 using Tapatalk

 

[The Cromwell]

If it does not work correctly?

 

[immykhan]

Tank is fine but hav doubts on my mod

Sent from my ONEPLUS A3003 using Tapatalk

 

[Johnnytraveler]

Give us details. What type of problems? What is your tank, mod, coils, batteries, etc.

 

[Khassy]

It's kind of self-evident if you are having problems.

 

[immykhan]

Obs engine rta but using it as single coil measuring .291 ohms
Mod is alien 220
Batteries lg he2
Am using fused clapton 3 cores
Some times the tastes vanishes as if i m vaping nothing

Sent from my ONEPLUS A3003 using Tapatalk

 

[immykhan]

When i use it with the head removed for cleaning the tank shows no problem, the coil burns fine

Sent from my ONEPLUS A3003 using Tapatalk

 

[Johnnytraveler]

Well if you have the normal engine (not engine nano), then I strongly recommend using it with dual coil. You can't shut off 1 side of the airflow. Lift your coils up high (even with top post holes) so that the side airflow hits the bottom 1/2 of them coils. Don't do a big build. The engine for me performs best Between 0.3-0.6 dual coil.

Some (like me) tried putting a single coil between the posts and rabbit ear your wick to use all 4 wick holes. But the airflow hits the end of your coils and not the sides. So not good flavor.

 

[immykhan]

I have normal engine but had some wicking problem with dual coil, one side burnt while the other side didnt work well. Will there b any problem with make of the coil?

Sent from my ONEPLUS A3003 using Tapatalk

 

[Johnnytraveler]

1 side burnt? Sounds like wicking problems. With the engines. Less is more. Don't stuff the wick into the holes so that the holes are filled. Gently place the wicked into the holes, keeping it loose. Any extra wick, just let it sit atop of the deck.

 

[immykhan]

I mean to say that when using it with dual coil both coils didnt burnt together(one coil burnt fine but other didnt) dats y m using it with single coil

Sent from my ONEPLUS A3003 using Tapatalk

 

[Johnnytraveler]

Ok test.
Use 1 coil on 1 side. Does it work? Now take that coil and move to the other side. Does it work?
Probably yes. Post holes can only be bad if they are stripped. If electricity flows through 1 post hole than it'll flow through the other.

 

[Johnnytraveler]

If the coils don't heat up at the same time then you need to massage your coils. Strum and pinch your coils so they heat evenly. Watch videos on how to install coils

 

[immykhan]

Sure i will try this way too

Sent from my ONEPLUS A3003 using Tapatalk

 

[Johnnytraveler]

Here's a good video on installing coils and wick. Start watching around the 13 minute mark.

You'll see he uses his tweezers to strum the coils to get them to heat evenly. I do the same but I use the top of the tweezers and not the tongs (points).

 

[immykhan]

Sure thx alot

Sent from my ONEPLUS A3003 using Tapatalk

 

[immykhan]

Does the amount of air has any thing to do with the quantity of juice used?

Sent from my ONEPLUS A3003 using Tapatalk