Need Advice

[BritVape90]

So I have been using an AR Mod with a Plume Veil. Works an absolute treat, my chasing of the cloud is well and truly over, this is however when I can get the connection between battery and atomizer. The issue is that the screw that goes up into the drip tray and connects to the "T" is not long enough to reach the contact to receive power from the battery. Either that or the pin that comes up through the 510 connection to meet the atomizer is not long enough. If someone could advise me on which one is not long enough and what i can do to maintain a good connection would be great. Please excuse my vocab, only been vaping for about a month or so

 

[BritVape90]

So I have been using an AR Mod with a Plume Veil. Works an absolute treat, my chasing of the cloud is well and truly over, this is however when I can get the connection between battery and atomizer. The issue is that the screw that goes up into the drip tray and connects to the "T" is not long enough to reach the contact to receive power from the battery. Either that or the pin that comes up through the 510 connection to meet the atomizer is not long enough. If someone could advise me on which one is not long enough and what i can do to maintain a good connection would be great. Please excuse my vocab, only been vaping for about a month or so

 

[Whiskey]

Hi and welcome to VU, I am sure some folks will be along soon to help you out with that, I however am not good at those types of details, but we have some great people here that know all about these issues. Good luck and Enjoy the forum

 

[JonnyBoy]

Based on my own experience only, the Plumveil doesn't have an adjustable pin. Along with AR not having one either, I can't recommend a safe way to remedy your situation. I believe you may just have a bad pairing of mod and atty. I can't say 100% sure because I've never owned an AR, but I know my Plumveil doesn't have an adjustable pin and doesn't work that well on my BABM. You may need to purchase a different atty or mod. Which luckily there is no shortage in variety of those floating around.

 

[OBDave]

I've had problems with Plume clones having the center pin get pushed up into the threads when tightened down too hard. I can usually remedy this a couple times by pushing the whole positive post down, but eventually the insulator wears out....