Ohms going up?

[DiegoMA]

Just started building today made some coils read on my deck 1.15 ohm (not touching other then from the pos and neg end) been vaping on it all day taste isn't the best but the big thing that's weirding me out is that the ohms are reading 1.36 any ideas?

I'm using a hobo clone and a rx200

 

[Cigmod VonToker]

Some times when you have have used your coil a little the ohm reading can rise slightly. But check your post screws. Back them out just a touch and snug them down again. That will often put your ohm reading right back to where it was, because the heating of the coil and posts can loosen things up even if its seems they are snug enough.

 

[pulsevape]

I wouldn't be alarmed your set up is just bedding in.

 

[VAPEROXX]

Yeah check your screws but don't sweat it too much.