RX 2/3 check battery issue

[iVape524]

hey guys just looking for some advice here. I had the RX 2/3 check battery issue where one of the soldering points broke off the spring loaded pin. I fixed it this morning and all is well I just want to make sure I am not going to have any safety related issues moving forward. All I did was take the mod apart and solder the joint back together. Everything is reading right and vaping ok, but I'd hate to have a situation on my hands because I've done a repair on the device. Thanks for the insight. Keep in mind I'll only be charging externally and I usually vape around 50-70 watts so I won't be pushing the decide wattage wise

 

[SirRichardRear]

hey guys just looking for some advice here. I had the RX 2/3 check battery issue where one of the soldering points broke off the spring loaded pin. I fixed it this morning and all is well I just want to make sure I am not going to have any safety related issues moving forward. All I did was take the mod apart and solder the joint back together. Everything is reading right and vaping ok, but I'd hate to have a situation on my hands because I've done a repair on the device. Thanks for the insight. Keep in mind I'll only be charging externally and I usually vape around 50-70 watts so I won't be pushing the decide wattage wise

you should be fine. TBH your soldering job is likely better then theirs.

 

[The Cromwell]

Should be fine.