Rx200 firmware 3.0 question

[emsvapor]

I recently purchased the rx200 and tried running TC with the stainless steel crown coils.

I currently am running 480° F at 50 watts and am hitting temp protection within a second of firing the mod.

Has anyone else ran into this problem or have a work around?

Thanks for any and all help guyd

Sent from my C6725 using Tapatalk

 

[skt239]

Are you using the pre-set for 316L or your own TCR value? Which coil, the .5 or .25?

 

[Ben-Rod]

They say the Crown coils have nickel leads, which throws tc off. You will need to run a tcr mode. There's a thread in which people listed tcr values that worked for them. Here's the link to said thread. It really needs to be made a sticky....
http://vapingunderground.com/threads/tcr-settings-you-find-work-on-the-realeaux-rx200.184152/

 

[emsvapor]

Are you using the pre-set for 316L or your own TCR value? Which coil, the .5 or .25?

The. 25 using the preset

Sent from my C6725 using Tapatalk

 

[Ben-Rod]

Set up M1 at 108 and play around from there...It won't hurt anything so don't be afraid to mess with it...

 

[emsvapor]

Set up M1 at 108 and play around from there...It won't hurt anything so don't be afraid to mess with it...

Set M1 to 160 running 520 at 70W right now and getting better

Sent from my C6725 using Tapatalk

 

[ajape]

Be aware that there's a point at which you might end up not getting any real protection from burning your coil, which would of course defeat the whole purpose behind using TC in the first place. I'm currently using my Uwell Crown 0.25 SS coil at 128-129 on the M1 TCR setting and 55-60 watts of power, and it seems to be the best balance I've been able to achieve so far that ACTUALLY still keeps a good, real temp protection for the cotton inside my coil, but of course as with all things vaping YMMV. Just something to keep in mind, enjoy your vape!

 

[gtrtech]

I'm running a crown with .25 coil on the ss setting,50 watts and 400-420 degrees with no problems.

 

[centella4u]

How do you set the TCR?


Sent from my iPad using Tapatalk

 

[Jim_MDP]

5 clicks OFF > hold Fire & Up to enter TCR Adjust Mode > use Fire to toggle between Register and Value > Right & Left to adjust values > hold Fire or just wait a few seconds to Exit.