I love this mod. I'm new to vaping. I don't understand what all this stuff means... How do I set it up to gets nice good flavor and vapor production ??? Which coil should I use ? How do I change the settings properly ? I can't seem to adjust what I want based off what I've read on other threads on here
Become a Patron!
RX200 with Crown tank - what am I doing ??!
- Thread starter anburnsao
- Start date
Easy route is use the 0.25 ss coil in wattage mode.
Prime the coil, install, let it sit for a good 5 minutes. Close air flow and take a couple easy pulls on it without firing the coil.
Start at 50w and if vape is ok, vape it like that for a good 20+ hits to break in the coil.
Start pushing watts higher till you get the vapor production, warmth & flavor you want.
You probably dont want to go over 65w to avoid burning the wick.
Later you can try temp control @ 60w ~500° with a TCR of 110 for the crown ss coils.
Instructions for the mod
http://support.volcanoecigs.com/hc/...6-Wismec-Reuleaux-RX200-Box-Mod-Instructions-
http://www.wismec.com/manaul/
Prime the coil, install, let it sit for a good 5 minutes. Close air flow and take a couple easy pulls on it without firing the coil.
Start at 50w and if vape is ok, vape it like that for a good 20+ hits to break in the coil.
Start pushing watts higher till you get the vapor production, warmth & flavor you want.
You probably dont want to go over 65w to avoid burning the wick.
Later you can try temp control @ 60w ~500° with a TCR of 110 for the crown ss coils.
Instructions for the mod
http://support.volcanoecigs.com/hc/...6-Wismec-Reuleaux-RX200-Box-Mod-Instructions-
http://www.wismec.com/manaul/
Last edited: