Sigelei 150 cleaning

[zaroba]

So, got my sig 150 in the mail yesterday and the instruction manual didn't detail anything about cleaning or replacing parts. Nor were any spare things included. So a few questions for those of you that have had them for a while.

#1
Common problem I had with my sig 100 was after vaping, condensation from vapor that was still released after a hit would accumulate around the base of my RDA. Then it would seep under the rda and when I did a rewick I would also have to use the tip of a twisted up paper towel to get any liquid out from around the pin. But, with the sig 150 having the floating pin, I don't see that as being easy.
So, how do you guys clean out that area?

#2
Is there a way to replace the spring for the floating pin if it were to break?
Like, if I was trying to get a pool of liquid out from around it and accidentally broke the spring.


I haven't had to do either of these yet.
Just asking for future knowledge.

 

[BoomStick]

1. Rubbing alcohol and a q-tip. Be generous with the alcohol then let it sit up side down for a minute. It will quickly and completely drain and evaporate.
2. I'm not sure about replacing just the spring, but it's possible to replace the entire connector with a fatdaddyvapes 510.

There are two little stickers in the battery compartment. If you remove the stickers (which will void any warrantee I believe), the two screws underneath the stickers and all the other visible screws you can completely disassemble the mod. You can then clean and repair as necessary. With no batteries installed you can use rubbing alcohol on anything including the chip. As long as you let it completely dry before applying power it won't hurt anything.

 

[slayer420-x]

Yeah I've noticed on my sig150 some moisture does end up on the top by my rda. Somtimes when i take rda off theres some juice under it. Havent had juice in 510 yet thankfully. All i do is use a paper towel and wipe around rda few times a day. Theres never big drops just condensation. I notice with rda screwed tight the airflow points towards button rather then to sides which is main issue i think. But 510 is long on sig150 so i think turning it half way back so its to sides is ok seems like its still connecting. That seems to help alot

 

[Zamazam]

Spray electronic board cleaner. Tip it upside down, give the 510 connection a couple blasts, let it sit upside down on a paper towel for 5 minutes, and you are good to go!