Become a Patron!

Smok osub 80w won't fire need some help!!!

P

pinky2444

I'm new to vaping it's only been two months I was building a set of parallel dual coils with 24 gauge kanthal and when I test fired the coils the one wire lit cherry red and a frowny face popped up on the screen along with a 30 second timer the vape will no longer fire or heat up a coil I've tried 3 separate heads with different coils it says the mod is only putting out .02 volts when fired I've tried adjusting the 510 connector on the heads and cleaning all the connectors now the heads I have tried on the mod will not read on the ohm meter
 
Last edited:
PhantomOp

PhantomOp

VU Donator
Gold Contributor
Member For 3 Years
Member For 2 Years
hrmm... how hot did the mod get? sounds kinda like you may have burned up the 510 pin wiring ...
 
PhantomOp

PhantomOp

VU Donator
Gold Contributor
Member For 3 Years
Member For 2 Years
It kinda sounds to me like the logic chip is toasted. Without tearing it apart you won't know fully what is wrong with it.
May be cheaper and quicker to just purchase a new MOD. There are a lot of really good ones out and price points that are hard to beat.

Two examples: SMOK Alien 220W TC Box Mod and Smoant Battlestar 200W TC MOD

Get some LG HG2, Sony VTC5a or Samsung 30Q batteries from a reputable supplier (see signature below) and your all set again.

burnt-circuit-board-20332777.jpg


And if your into building coils, I would highly recommend getting an ohm reader. This will save your MOD from getting fried again.
Geekvape 521 Tab Mini | Coil Master 521 Tab Mini
 
Last edited:
You must log in or register to reply here.

VU Sponsors

Top