S13hitman
Member For 1 Year
I now see they are just crimped/pressed from the factory without anything to tighten down.
My tank will not come off due to the 510 connection just spinning in place. The crazy part is it works fine but not serviceable.
I did try to epoxy it in place without luck. It looks like my only option is to desolder the board and disassemble it completely unless you guys and gals have a trick. I have desoldered the bottom portion previously to clean out oil build up when it stop working or fired by itself.
Hope this isn't trash yet, I like to fix shit...
My tank will not come off due to the 510 connection just spinning in place. The crazy part is it works fine but not serviceable.
I did try to epoxy it in place without luck. It looks like my only option is to desolder the board and disassemble it completely unless you guys and gals have a trick. I have desoldered the bottom portion previously to clean out oil build up when it stop working or fired by itself.
Hope this isn't trash yet, I like to fix shit...