Smoke Xcube 2 & TFv4

[alchy]

Hi just got these 2 and decided to go sub ohm. I have watched quite a few videos on setting this up. When in Temp or Watt mode on any wattage currently set to 50w my coil is 0.15 ohm, 50w, 2.75v coefficient is set to .006 nickel dual coil. I am using the quadruple coils.
The device powers up and not much vapour comes out less than my old svd 2.0 + Nautilus Aspire setup. I find the throat hit pretty bad and the base of the FTv4 gets very warm even after a few triggers. I have tried my Aspire Nautilus on the Smok xcube 2 and it works the same as on the svd 2.0 so no problems there. Can anyone help to try and get it working right?

Thanks in advance Dave

 

[qasisalso]

I have that exact setup and mine works great think u may have complicated things by changing the co efficient on BEC app reset that only use watt mode as no need for temp untill you get used to the tank ( Back in my day ) kinda thing then work to temp afterwards. The quads run over 100 watts but that's way to hot for me lol 70 is a nice vape in MHO

As for getting warm / to warm
Sorry bud that's the price you pay for coils the size of your little finger lol they do heat up but unless it feels worryingly warm I wouldn't worry
Don't forget you can open the drip tip for more air
Hope this helps and hope I have explained OK lol good luck


Sent from my SM-N9005 using Tapatalk

 

[TheFog]

Am I wrong or is the temp control on the TFV4 not necessary because the coils aren't nickle?....u didn't think they even had temp coils out for this tank yet

Sent from my SAMSUNG-SM-G870A using Tapatalk

 

[qasisalso]

I'm not sure lol but the way I work it is the temp control is great for long sustained hits even on non nickle I don't think the coils are nickle but would be very jubious about changing co efficant on a pre built lol

Sent from my SM-N9005 using Tapatalk