subtank, delta and lemo rba ni200 build

[dre]

Lots of wasted wire and sleepless nights and I finally mastered a build where I can pump 40 watts @470 with only 6\7 wrap (6 is on top 7 on bottom)and its not flimsy! 1st Twist 30g until 10 ridges can fit inside 3.5mm length of wire. Use a 3mm rod for the coil. Wick the coil with fluffy JP cotton and use the pancake method so juice will rest inside the rba in front of the cotton ends. I think people forget to account for the heat flux of the wire. A single strand of 28g or 30g can't hold 40 watts unless its a shit load of wire. Thought I'd share this with y'all sorry if its poorly written.
(Will ohm out to .11) and shouldn't refine if your connection is solid

 

[Rommel]

Thanks! Im going to try this out.

 

[dre]

Thanks! Im going to try this out.

My temp stays around 410° due to the thickness of the wire. 40watts seems to be the sweet spot or this build in a lemo drop it performs even better. Let me know how it works out for you. Remember to twist the best wire til it breaks. You want it tight.

 

[Rommel]

Well, this all fell apart once i discovered i had no 30 gauge Kanthal. But a thin roll of mesh seems to work fine, i can now use more watts and also the flavor got even better. So i have 0.18 coil, with mesh-muji hybrid wick. Works great around 35w and 450F.

 

[dre]

28g works to just takes a second to ramp up.
The key is twisting it to the maximum

 

[dre]

Triple twisted 30g rest. At .10