Temp Control Mod Help?!

[Nitrowolf72]

I'm looking at getting a tc mod but can't make a solid decision on one. Hopefully someone can give some pointers on which will be my best bet. I've done quite a bit of reading and the more I read the more I don't know which to settle on. My choices so far are:

Snow Wolf 200
IPV 3LI
IPV 4S
Sigelei 150

Or any recommendations?
Thanks.

 

[opiedowns]

The Snow Wolf is nice I have one. Sigs are good mods too (I don't know about the TC though). Have you looked at the DNA 200? The Whiteout looks nice.


Sent from my iPhone using Tapatalk

 

[vegaschef702]

I have ipv4 and I love it. Just did my updated for titanium wire and 100 joules and 120 watts with kanthal. I haven't purchased titanium yet. But since day one I've had no problems with it and still use it daliy.

 

[Maverik_X]

sx mini m class is the best but also most expensive.
second choice is ipv3 li
sig150 tc same chip as the li just different gui interface and only 150 watts
ipv4 or ipv4s essentially same devices the 4s has charge board removed revised chipset and some rebranding.

be on the look out for the pioneer4you iPV D2 its a smaller device and fairly good price will have tc and yihi chip. supposed to be released soon

 

[Heather]

I don't have any of those devices. I have a Vapor shark rDNA40 and a Hana mod V4S. I love TC though and have hardly used my vv/vw mods since I got the TC.

 

[kwtony]

#gameoversetup

 

[kwtony]

I NEED temp control down at MM 0, because its hot as hell. Evic .41ohm Ti subtank hybrid and some delicious Halo Shamrock ....

 

[Cruel-Phate]

I have the black ipv4 and I have had no problems, it's been a great device so far regarding TC and the upgraded firmware no problems.

evic vt is also a good choice, it's smaller than ipv4 but it's also been s stable device and battery last all day, I like the huge display on the evic, between the two I think I prefer the ipv4

 

[kwtony]

The ONE thing Im not huge on is the lcd in the sun...then again..i dont need to know anything other then that its on....if its too hot, i turn it down till im happy...its so easy i dont even have to think about it....so it may be an issue, but not so much of a problem for me...

 

[Nitrowolf72]

As of right now, I'm leaning heavily towards the ipv3 li. Not a final decision yet but pretty close.

 

[Nitrowolf72]

Thanks everyone for your input. After looking, looking and some more looking I went with the IPV3 Li.

 

[USMCotaku]

I've never been a big p4u fan, due to lax QC. Things like battery doors not aligning right drive my ocd tendencies crazy, but yihi chips are pretty solid.
Sent with one hand, the other is busy vaping.

 

[Nitrowolf72]

Well most of my box mods are sigelei but I have a ipv mini 2 and so far I've been very satisfied with it so I thought I would give the ipv3 li a chance. Hopefully it will be a good mod.

 

[Mroutlaw]

I own most of the tc mods out right now. If money isn't a factor, the sxmini m class is the best one out right now. Next up would be the ipv3. If your on a tight budget, the evic vt is pretty good and available for around $50.

If you are looking for a lot of power, consider waiting for the dna200. But keep in mind, these 150w and 200w devices only give you that power in kanthal mode. Most units cap you at 60-75watts in tc mode, which is more than enough. The sx goes to 75j, which is about 80watts


Sent from my iPad using Tapatalk

 

[Nitrowolf72]

Thanks MrOutlaw. I decided on the IPV3 Li.