Tfv8 baby beast rba problem

[MaLiXs]

Hey everyone I got a little problem here with my baby beast... I've tried to use the rba option on my tank and my mod is unable to read the resistance of the provided coil. If I use the premade coil the resistance is read perfectly (I use a Kanger kmod tc 75 mod)

I've tried to see if the coil is touching the post or the deck...

I could probably try some coil that I have buy for my previous tank, could I try those one ?

Sent from my Nexus 5X using Tapatalk

 

[inspects]

Yes you could, it says .2 ohm on the package I believe.

 

[anen]

Can't read what is written on the package but that coil is large (6-7 wraps). My guess would be .5-.6 Ohm coil. Irrelevant anyway. As inspects said yes you can use it just read those values from the package and go from there if you decide to throw it on a mech mod.

 

[TheRealSean]

Iam just asking not familiar with mod what dose sreen say ohms too low? If you have q2 coil in it and its ok at .4. Or if you have the t8 it reads at .15 and still ok. You should be good rba rated at .3 give or take alittle after pulsing wicking. If it says atomizer short recheck your build make sure rba screwed in and deck sleeve not loose. Find out how low your mod will fire down.

 

[NickIsANoob]

Make sure the RBA is screwed together very tight the base can unscrew and break connection

 

[MaLiXs]

I've tried to screwed really tightly and nothing changed

Sent from my Nexus 5X using Tapatalk

 

[SirRichardRear]

what mod are you using?
Those coils say .2 ohms (which is approx) if you do a dual coil it should be .1 but could wind up as .09 and be out of range so knowing the mod is pretty important. which coils did you use when you had premade ones?

 

[MaLiXs]

I'm using a Kanger kmod tc 75. As I said in the first post I've used the non rebuild coil and they work great.

Sent from my Nexus 5X using Tapatalk

 

[SirRichardRear]

I'm using a Kanger kmod tc 75. As I said in the first post I've used the non rebuild coil and they work great.

Sent from my Nexus 5X using Tapatalk

I couldn't find kmod, i assume you mean kbox mini TC 75 watts?

If thats the case, using those coils in a dual coil config might be below the resistance minimum. Have you tried using those coils in a single coil on the RDA?

Other then that, make sure everything is tight as everyone suggested. all the screws on the RBA deck and make sure it's screwed all the way into the base of the tank.

 

[MaLiXs]

I can't use the baby beast in a single coil configuration

Sent from my Nexus 5X using Tapatalk

 

[SirRichardRear]

I can't use the baby beast in a single coil configuration

Sent from my Nexus 5X using Tapatalk

actually it looks like the pic says .5 ohm per coil which means a dual should be fine. do you have another mod to try it on? or maybe an ohm meter to check it?

 

[MaLiXs]

Yeah it supposed to be 0.5

Sent from my Nexus 5X using Tapatalk