Good afternoon fellow vapers.
This is my 1st post, so hopefully I've chosen the right section.
My current DIY issue, (as they seem to mount up constantly), is the tickle I'm getting in the back of my throat, when using my RTA and RDA's.
As it stands I'm using:
TFV4 - 26g Kanthal reading 0.43ohms.
Orchid V4 - 26g Kanthal reading 0.40ohms
Velocity Clone - 26g Kanthal reading 0.77ohms
I'm running all at around 40w as was advised to by my local vape shop. The
flavour is brilliant, but after a few pulls I feel a tickle in my throat and soon after I begin to splutter like a maniac.
It doesn't hurt my throat in any way, but its a real pita!
I have also tried vaping at 30w and still get the same annoying tickle. If I take it down any further the flavour goes to pot, as it's not hot enough to heat to wick properly.
I'm using juice that I have made, it's 3mg 70/30 VG/PG.
Any advice from people who have over come this or a similar issue would be greatly appreciated.
Jack
This is my 1st post, so hopefully I've chosen the right section.
My current DIY issue, (as they seem to mount up constantly), is the tickle I'm getting in the back of my throat, when using my RTA and RDA's.
As it stands I'm using:
TFV4 - 26g Kanthal reading 0.43ohms.
Orchid V4 - 26g Kanthal reading 0.40ohms
Velocity Clone - 26g Kanthal reading 0.77ohms
I'm running all at around 40w as was advised to by my local vape shop. The
flavour is brilliant, but after a few pulls I feel a tickle in my throat and soon after I begin to splutter like a maniac.
It doesn't hurt my throat in any way, but its a real pita!
I have also tried vaping at 30w and still get the same annoying tickle. If I take it down any further the flavour goes to pot, as it's not hot enough to heat to wick properly.
I'm using juice that I have made, it's 3mg 70/30 VG/PG.
Any advice from people who have over come this or a similar issue would be greatly appreciated.
Jack
Last edited: