triton 2 question

[kleenkut]

I am new to vaping and currently vape a triton 2 with either a .3 ohm or .5 clapton coil. My question is regarding the position and visibility of the wicking holes of the coil when in vaping mode (top fill holes closed and wicking widows open). Will the coil wick the best with the entire coil wicking hole visible or with only half the wicking hole visible? Since the wicking windows are 180 degrees from each other I was not sure if two of the coil wicking holes would be blocked if the entire wicking hole of coil were visible. If set where only half were visible would this then mean that all four coil wicking holes were half open thus allowing better saturation? Can some of you experienced members help enlighten me on this. Being a new member both to vaping and to the forum, I really appreciate the patience and helpful advice that I have gotten here.

 

[VapingMurse]

I am new to vaping and currently vape a triton 2 with either a .3 ohm or .5 clapton coil. My question is regarding the position and visibility of the wicking holes of the coil when in vaping mode (top fill holes closed and wicking widows open). Will the coil wick the best with the entire coil wicking hole visible or with only half the wicking hole visible? Since the wicking windows are 180 degrees from each other I was not sure if two of the coil wicking holes would be blocked if the entire wicking hole of coil were visible. If set where only half were visible would this then mean that all four coil wicking holes were half open thus allowing better saturation? Can some of you experienced members help enlighten me on this. Being a new member both to vaping and to the forum, I really appreciate the patience and helpful advice that I have gotten here.

Welcome Kleenkut!

So i think i understand what you're asking though i've never owned a triton 2. I just looked up pictures for better clarification on this though. With these coils (from what i can see in the pictures), it will wick properly as long as they are screwed in securely, regardless of how the window appears on the tank. It may just be the alignment. If you would be so kind as to upload a picture of what you're describing, it would help a lot for accuracy purposes of the explanations!

Vape On!
Murse

 

[Eskie]

I have a Triton mini (not a 2) but the chimney and juice holes are he same. No need to line anything up as far as the coil juice holes to the chimney juice holes on a mini, so I believe you're fine on the 2.