Become a Patron!

Trying to start with building but don't know where to start

S

Schyzo

Hi guys,
With the EU attacking us vapers everywhere they can by taking away our tanks and such I fear soon they will take away all tanks and coils.
So I want to learn how to make my own coils seeing as they will never be able to restrict the wire and cotton.
But I can't even think about dripping, So are there tank based building kits ?
I looked up on how to twist the wire and staple coils and so on.
I am familliar with Ohm's law and how to calculate that.
And if they do exist what are decent starter tanks, however they have to be 2ML or under else i can't import them.
(one of those BS laws I talked about earlier)

Thanks in advance

Schyzo from Holland
 
Jimi D

Jimi D

Gold Contributor
ECF Refugee
Member For 5 Years
Before building all those fancy "oh so pretty" coils. Start with simple builds first.
 
nightshard

nightshard

It's VG/PG not PG/VG
VU Donator
Gold Contributor
Member For 4 Years
I would suggest starting with a simple single wire build before jumping into more complex builds.
Also start with Kanthal and later on you could try SS.
I would get a spools of 28,26,24 and start experimenting.
There are many recommended RTAs but none that I know of that is 2ml.
You should choose an RTA with a velocity style deck which is easy to build on.
I suppose that if you order directly from China, no one is going to open your mail and measure the capacity of the tank.
 
S

Schyzo

nightshard said:
I suppose that if you order directly from China, no one is going to open your mail and measure the capacity of the tank.
Click to expand...

You clearly don't know how pity the Dutch Customs agents can get :p
My Drip-tips from China were held once for an entire week by customs.
But thanks for the tip on the Kanthal
 
MyMagicMist

MyMagicMist

Diamond Contributor
ECF Refugee
Member For 5 Years
Schyzo said:
also how is this ?
http://www.3fvape.com/rebuildable-a...ver-stainless-steel-pc-2ml-22mm-diameter.html
I like the fact it's completely made of steel not glass, seeing as my vape has a habit of sliding out of my pocket (got to love those new red cross uniforms with their fragging teflon materials)
Click to expand...

Well, if the PC in this case is meaning Polycarbonate, I would avoid this tank unless you're sure beyond doubt any juice you use will not be a tank cracker. A lot of menthols, cinnamon, citrus juices crack tanks.

Here are a few:

https://www.fasttech.com/products/0/10009118/1687002-3d-rda-rebuidable-dripping-atomizer

https://www.fasttech.com/products/0/10005349/1651801-authentic-smoktech-dripper-rda This one can be converted to use a bottom feed pin. Your mod can hold a plastic bottle with the juice. Look more into the bottom feeder thread. You can find info there on how to either use pre-made bottom feed pins for the conversion, or doing it a quick and dirty way. This RDA is stainless and brass. Granted it's only single coil but you build a good coil, you got a good vape.

As for building tanks? Well that's a little beyond my scope presently, despite having a torch kit and copious scrap metal laying around. I would suggest looking that up on Youtube or other such video sites. Fairly sure someone more than likely has taken a notion to do it and show how.
 
You must log in or register to reply here.

VU Sponsors

Top