Become a Patron!

Tugboat v2, the little atty that could!

audio-neon

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Long story short, I sold my doge today for ~110$ and had to buy a new atty. So I walked over to the authentic case and was going to snag a sexy veritas, but found the airflow to restrictive. Due to a good week at the shop, there really wasn't anything in there to wet my lips, pun intended. I built the veritas, a couple rips and I wasn't getting the vapor that I wanted. Sitting on a JA mods victoria was a little brushed Tugboat v2.

Had some twisted 24g kanthal, a quick build and some 50/50 blend juice. Voila it chucked dense clouds without evening being built for clouds. So the point of this post is to tell you guys that if you missed out on a tugboat due to the small issues with it, buy the v2. It is a beast.
 

Saddletramp1200

Diamond Contributor
Member For 4 Years
I have tiny Smok Tek about the size of a little finger. It blows big clouds. Sometimes size don`t matter.
 

audio-neon

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
The "little" was more of an figurative statement.
 

Rommel

Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
I could not agree more. Tugboat V2 is my favorite now, side by side with the Plume Veil. Beautiful pieces.
 

Jah

Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
is it less leaky than the V1? i always had a puddle underneath the atty
 

Rommel

Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
My V2 has not leaked one bit. Tested with 50/50 and pure vg, no leaks whatsoever. Also the wicking was shit, still no leaks.
 

Rommel

Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
My V2 has not leaked one bit. Tested with 50/50 and pure vg, no leaks whatsoever. Also the wicking was shit, still no leaks.
Correction. Something seeps through the o-rings and the bottom of your atty is somewhat sticky always. Put a bigger o-ring in place and it should stop. So not too bad.
 

Breeezy

Member For 4 Years
Member For 3 Years
I like to throw my mutation X top cap over my v2 deck, that copper center post knows how to chuck some clouds.

not top cap, the whole top piece of the atty***
 

SouthPhilly

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Ya... Picked up a Tugboat V2 a few weeks ago... Love it for my everyday setup... running it with 24g 8wrap, @.32ohm on a Doomsday mod with a Efast 18650 3.7v 2500mAh...

Hands down my favorite setup.

And to think... i started vaping to quit smoking.... now i need a bigger box.
 

red6

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Ya... Picked up a Tugboat V2 a few weeks ago... Love it for my everyday setup... running it with 24g 8wrap, @.32ohm on a Doomsday mod with a Efast 18650 3.7v 2500mAh...

Hands down my favorite setup.

And to think... i started vaping to quit smoking.... now i need a bigger box.


Baaahahaha I started vaping to quit smoking as well.
I've spent 10 times the money on vaping then I ever did smoking. Now I make my own juice just to save some money. Not bad though 2 liters of juice for $30.00 instead of $20.00 for 30 ml.
Still vaping 15 to 25 ml a day though
 

VU Sponsors

Top