Become a Patron!
upgrading ipv2s
- Thread starter Rizky
- Start date
are you running the application as administrator?
When you plug in the device does the OS recognize the device and load the drivers?
64 bit I would suspect...maybe try running the app in compatibility mode under a 32 bit wrapper
be careful when upgrading firmware...if it hits a snag once it starts writing...it can brick the device
When you plug in the device does the OS recognize the device and load the drivers?
64 bit I would suspect...maybe try running the app in compatibility mode under a 32 bit wrapper
be careful when upgrading firmware...if it hits a snag once it starts writing...it can brick the device
Yes i'm running it on administrator, the OS didn't recognize the device. So should I upgrade my ipv2s?
Could be the USB cable
Is there a manual or application that comes with your device?
Is there a manual or application that comes with your device?
no, only manual book.
I had the same problem whit IPV2S, device not found, it was because the USB driver was not instaled on my computer. For instal it you need to remove your battery then connect the IPV2S whitout battery ( normaly your IPV2S must be reconized). Now you can launch SXi program ( whit your device connected whitout battery), begin whit "connection icon" and "instal driver", then click connect button (you have message : "connected"), continue whit "upgrade icon" and "open file" to search your firware (.sxi) and finish by click on "upgrade button", wait and enjoy 
one video here :
Sry for my bad english. i hope you can understand me and i have help you.
one video here :
Sry for my bad english. i hope you can understand me and i have help you.