I used TI on a dna 200 and it just wasn't getting it compared to nickel. Now I have a IPV3 Li, so I need to try it on that.
Become a Patron!
What type of builds are you using in your Temperature Control Device
- Thread starter Mroutlaw
- Start date
I've tried TC on The Snow Wolf, Sigeli 150 TC, and now the IPV3 LI and the IV LI has done great with both, Titanium is just so much more forgivable
Ive discovered that when using 26g Nickel, that a 15 wrap micro coil (20 gauge pin) works out to be .09 ohms.
Great flavor with a decent cloud, nice and dense warm vape.
Might try a dual coil setup next with 18 wraps.
This small of wire, being nickel is NOT very forgiving.
Great flavor with a decent cloud, nice and dense warm vape.
Might try a dual coil setup next with 18 wraps.
This small of wire, being nickel is NOT very forgiving.
Can you post a pic of the build
TF Vaping
Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Comes out to 0.15, run tc 320°F at 70 watts on my snow wolf, Scottish roll wicking is a must.
Sent from my Nexus 6 using Tapatalk
Nice build
ajaymes2001
Member For 5 Years
I have the Lavabox dna200 with a mutation x v4 a billow v2 and a Smok TFV4 all with ni200 builds. The mutation has dual claptons 8 wraps each 26g nickel core with 36g kanthal wrap and the temp control works perfectly and it even clouds decently well. I run it at 435f wits the preheat punch turned up all the way. In the tfv4 I have a single 4 strand twisted 32g nickel 8 wrap single coil around a 2.5mm screwdriver and in the billow I have 3 strand twisted 32g dual 8 wrap coils around a 1.5mm screwdriver.
hi all
im using a kayfun v4 with a eleaf tc60w
building at 0.21ohm about 10 wraps spaced with nickel ni200 3mm inner diameter
and my wick is native wick
im vaping at about 20-25w at 380-420f
im having issues with keeping my wick from burning in the center
after 2h of vaping i get a burnt taste and open the deck to see a nice black spot in the very center of my coil
any help would be much appreciated
thank you
im using a kayfun v4 with a eleaf tc60w
building at 0.21ohm about 10 wraps spaced with nickel ni200 3mm inner diameter
and my wick is native wick
im vaping at about 20-25w at 380-420f
im having issues with keeping my wick from burning in the center
after 2h of vaping i get a burnt taste and open the deck to see a nice black spot in the very center of my coil
any help would be much appreciated
thank you