A couple of things I noticed. Depending on what type of coils you are using, you wlll get more or less runtime /per ml. When I was using SS316 Claptons (26, 32) I had to crank up the power to heat up the coils (more metal mass). When I use SS430 28ga dual coils, I get about twice the runtime (going through about the same amount of juice). I'm saying it's hard to compare I get x amount of ml's per run unless you are using the same coils and power settings.
There are ways to try and squeeze extra runtime out in Escribe. The default setting is the screen stays on for 60 seconds after firing. I lower mine to 30 seconds (that's more than enough as far as I'm concerned). You can also adjust the screen brightness, etc. It might not make a huge difference, but every little bit helps!
Cheers,
Steve
There are ways to try and squeeze extra runtime out in Escribe. The default setting is the screen stays on for 60 seconds after firing. I lower mine to 30 seconds (that's more than enough as far as I'm concerned). You can also adjust the screen brightness, etc. It might not make a huge difference, but every little bit helps!
Cheers,
Steve