I have the kayfun black edition. I can build it just fine with 32 gauge wire or smaller. But at that gauge my coils tend to last only a few days. I would like to make them with 28 gauge wire.
But with the thicker wire, I just can't seem to get the screw to tighten up on it. I will think I have it placed correctly, and tighten down, only to have the wire pop out, over and over. I tryed buying some screws from amazon, that looked like they had flatter bottoms, but once I got them, they were still slightly rounded. So they still popped out, every time.
So, does anyone else have this issue, and what did you do to fix it? Either a special technique or buying different screws, etc.
But with the thicker wire, I just can't seem to get the screw to tighten up on it. I will think I have it placed correctly, and tighten down, only to have the wire pop out, over and over. I tryed buying some screws from amazon, that looked like they had flatter bottoms, but once I got them, they were still slightly rounded. So they still popped out, every time.
So, does anyone else have this issue, and what did you do to fix it? Either a special technique or buying different screws, etc.