First off, hello to everyone this is my first post on here.
I have been using a Nemi clone/Trident V2 clone for a bit now and am looking for something I haven't had much luck in finding after checking around a few places. Hopefully someone on here could help me out. I have checked 101vape, Ebay, FT and a few other sites.
I am looking for a cheap mod (clone is fine), that is/has.
1. Brass
2. No markings or logo's (this is the difficult part).
3. Single tube (18650)
4. Adjustable 510 contact pin
5. Flush firing button, non locking
Basically a Cartel style brass mod but without any engraving. The Cartel mod would be perfect it is wasn't for the engraving on the tube. Heck even if I could find a tube that fit the Cartel that was plain to put in place of the one they have that in engraved would be nice or a clone that is only laser etched rather than engraved if it isn't to deep to be able to sand it out. I have seen that they sell the laser etched one's but not sure how deep it is.
I would like to do a forced patina on it so a surface without engraving would be nice. Thanks for any advice you could give.
I have been using a Nemi clone/Trident V2 clone for a bit now and am looking for something I haven't had much luck in finding after checking around a few places. Hopefully someone on here could help me out. I have checked 101vape, Ebay, FT and a few other sites.
I am looking for a cheap mod (clone is fine), that is/has.
1. Brass
2. No markings or logo's (this is the difficult part).
3. Single tube (18650)
4. Adjustable 510 contact pin
5. Flush firing button, non locking
Basically a Cartel style brass mod but without any engraving. The Cartel mod would be perfect it is wasn't for the engraving on the tube. Heck even if I could find a tube that fit the Cartel that was plain to put in place of the one they have that in engraved would be nice or a clone that is only laser etched rather than engraved if it isn't to deep to be able to sand it out. I have seen that they sell the laser etched one's but not sure how deep it is.
I would like to do a forced patina on it so a surface without engraving would be nice. Thanks for any advice you could give.
Last edited: