AmPped
Member For 2 Years
Ok..So, just started vaping within the past week. I have an eleaf I just S. Just worked out the tank leaking issue (pretty sure the coils that are sold with those kits were the culprit for whatever reason) After a bit of research and trial and error this week I discovered FLAVOR is the most important to me and I prefer direct to lung hits (sub Ohm?). I currently have a .18 ohm stainless steel eleaf coil in there. I do get kind of bored with one flavor after about half a day, so as of lately, I have been taking out the coil and going through a whole process of cleaning the tank and parts... DAILY. It's quite a process, and I haven't wanted to alter the flavor of the new juices by using the same coils in the new clean tank...So I've been wrapping my once used coils in a paper towel, sticking them in a baggie labeled with the flavor they were used for to be reused next time I want to vape that flavor, and putting a fresh coil in with the new flavor...My question is...Can I do this??? I am not sure how I feel about washing the coils in water... Cotton and water in my mind = mold?.....Or the potential of mold or of rust of the metal of the actual coil part? Also not sure if wrapping them like I have is the right way to go either lol. I know there has got to be a better way of doing this... I'm thinking later down the line I will purchase a couple extra tanks and just swap those out when I want a switch up..But, for now though....Any info or recommendations would be super appreciated. thanks!!!