I'm new here, not sure if I am putting this post in the correct place or not so please bare with me.
Today I changed my coils, and I used the RBA that came in my baby beast tank kit. The shop owner, where I purchased it from, helped me and showed me how to wick the coil, so it was already done for me..
I cleaned my tank as normal, took out the old coil and installed the RBA just as I would any other by screwing it in....
Once I filled the tank with my juice and began vaping again, I noticed that it didn't pull as hard as before. I have it set at 62W and the ohms are set to 0.301...
Am I supposed to change any of that when I switch to RBA?
Also there is a lot and I mean A LOT OF SOME SERIOUS POPPING GOING ON. Does anyone know what the cause could be? Any help would be greatly appreciated.
Thank you
Oh. At 2.25seconds that's when it started pulling like I wanted it to but it's also when it started popping like firecrackers
Today I changed my coils, and I used the RBA that came in my baby beast tank kit. The shop owner, where I purchased it from, helped me and showed me how to wick the coil, so it was already done for me..
I cleaned my tank as normal, took out the old coil and installed the RBA just as I would any other by screwing it in....
Once I filled the tank with my juice and began vaping again, I noticed that it didn't pull as hard as before. I have it set at 62W and the ohms are set to 0.301...
Am I supposed to change any of that when I switch to RBA?
Also there is a lot and I mean A LOT OF SOME SERIOUS POPPING GOING ON. Does anyone know what the cause could be? Any help would be greatly appreciated.
Thank you
Oh. At 2.25seconds that's when it started pulling like I wanted it to but it's also when it started popping like firecrackers