This is the excat set up I'm using on the RX 3 and my older sigelei. I dont have an ohm reading and I know I should get one. But my current set up works on everything just not the sigelei 150 TC .and yes reading .2 it should. I used a baby beast to double check it that's how I know it's reading half .I put the premade coils with resistance reading 1.5 ohms and they would work but the resistance was not reading correctly . These test were done awhile back I just threw my mod in abox and said well it's screwed. But now that my rx3 is having issue I'd like to have a few backs up for times when I main mod is down .
Ok, so let me just get this straight in my mind - Correct me if any of this is wrong / tackle the Q's
Wismec RX3 -
You were using a VGOD RDTA on it and what you were getting overheating problems Leading you to order a new heatsink for it? What was it actually doing - just getting too hot for your liking? Giving an error message?
What was this reading your coil resistance at? Did you consider this to be over-reading/ under reading / About right?
Sigelei 150 TC mod
You've tried using your VGOD RDTA on it and it doesn't work? how so? Is it not firing or what? Are you just saying it doesn't work because it measures your actual VGOD RDTA coil resistance at half of what it actually is?
Have you tried anything with this mod recently or has this been chucked in a cupboard without you going near it since you tested it some time ago with a Baby Beast tank and found it to be reading half of the resistance of 'known resistance' stock coils?
Did you just test it with one smok coil? or multiple smok prebuilt coils? If you did test it with multiple coils did you use different coils with different 'known resistances' and was it reading 1/2 of what they actually were each time?
The Sigelei 150
This is what you are using right now? Are you using your VGOD on it or are you using the Baby Beast on it? Is it behaving completely normally? Reading resistance correctly?
Nugget 50w.
Which version is it? The 2000mA version/ V1 / V2 ?
Did you test both your VGOD and your Baby beast on this?- is this mod working now with both setups?
Tanks-
Smok baby beast - Have you got this now? If so, what coils are you using in this? If its an own build what is the setup?
VGOD RDTA
What setup are you using and are you using premade coils? If so what is the specified resistance of each coil?