I got this mod about 10 days back and the 510 pin is stuck to the mod, the tank comes off not the pin I tried blowing hot air from a hair dryer but that didn't seem to help
it worked for the top of the tank not for the bottom partTry channellock pliers with a towel around the base of the atty. Don't squeeze hard or you'll bend the base, it should unscrew for you. I've used this method on numerous attys without causing damage.
Put the whole thing in the freezer for a while, then try the channel locks again.it worked for the top of the tank not for the bottom part
Put it in for 5 mins but when i removed it, it was covered with droplets all over might be because of the weather of where i live just wanted to confirm, these tiny droplets wont do anything to the mod right?Put the whole thing in the freezer for a while, then try the channel locks again.
Shouldn't, and you shouldn't need to leave it in the freezer for more than about 10 minutes.Put it in for 5 mins but when i removed it, it was covered with droplets all over might be because of the weather of where i live just wanted to confirm, these tiny droplets wont do anything to the mod right?
tried it, didn't workShouldn't, and you shouldn't need to leave it in the freezer for more than about 10 minutes.