Watts mode also lets me know as soon as my RDA starts going dry. At least for me, temp control is not needed for that. And I never pull the cap to check. I always just squirt down the drip tip. All temp control does for me is it just wrecks the vape experience. Doesn't matter which setup I try or use... it's still one big fail to me─also regardless of how I dial it in. Either that, or it doesn't improve anything at all so it's still nothing more than a perfect waste of time. The problem just persistently repeats itself each time when I install a new coil build. Tried to dial in temp control on so many different mods now... always by screwing my RDAs onto a different mod, and then another mod, and another RDA, and and... seriously. Fuck temp fucking control. Just fucking fuck it. Finally, if your coil build consists of a Nichrome80 wire wrapped around Kanthal core wires (one of my personal favorite ways to build my own coils), then temp control will be pretty much impossible. So if it works for you, then do it... it's the holy grail for you. For me, it just makes the mod more expensive for no good reason whatsoever.I'll take all that kanthal. I tc kanthal very well in the Hohm Wrecker. Seriously, it vapes extremely well. I have my current setup dialed in so well I can't go back to watts. I know as soon as my rda starts going dry and it makes it easier to drip on since I never have to pull the cap to check. Just a squirt down the drip tip and off I go. Of course everything else tc's well too, but it's cool (to me) to use kanthal. I still have a few spools of ss waiting for me at home though just for ramp times. I can see why some wouldn't want this block and it's silly symbols though. Too bad the fsk chipset isn't going into more mods. It's a wasted technology that has real merit.
Sent from my ONEPLUS A3000 using Tapatalk