Hello! I got a Sigelei Moonshot RTA, and while I absolutely love its performance, I had some issues that I need some advise on. When I was building it using 24 gauge Kanthal A1, I was getting vastly different readings on both my Smok Alien, and my generic minitab. Sometimes I would make a build the way I liked it, and wicked it, and then when I put together the entire tank which was supposed to have an ohm reading of around 0.4 my Alien read it as 1.xx or even 2.xx. I tried to dry burn the coils on my minitab, but it did not want to work. It read the ohms, but didn't want to dry burn. Is there a minitab that anyone recommends where I could dry burn my coils? I was using my mod to dry burn the coils when priming it, and after I primed it, my mod read the ohms really high, in the 1.xx-2.xx range. Could it be because the coils were hot, and the mod thought it was a new coil with a much higher rating? Also, I would frequently get a message on my mod saying that the ohms were to low, or that there was no coil even though the tank was on my mod. Last night I made a new build, which was turning out to be great, but when I put the whole tank together and fired it, I saw a bright flash in the tank, and a burning smell. Doe anyone know what I could be doing wrong? Also does anyone know where I can buy replacement screws and what size screw driver I would need? The RTA came with an allen wrench, but I found it to be to small in my big hands, and I would like replacement screws just in case.