burn

Im using a Vandy Vape Pulse X with an Vandy Vape Pulse X RDA with a single SAMSUNG 2500mAh 3.7V 25R battery,and at 20 watts after 3-4 puffs, the body gets very very hot,and at 40 watts,the heat almost melts my frosted ultem cap,I use 2 coils at 0.12 ohm. What could be the problem?

Hello all I've been vaping for awhile now and never had a problem like this. I've been using the tfv12 for a few months and everything was fine, no major problems. Recently, though, it seems that every new coil head I install in the tank burns the very same day and it has been happening entirely...

Hello! I'm new to vaping, my friend helped me to order an e-cig. It is a Joyetech evic primo SE with an OBS engine nano (they're both clones). It always reads the resistance bad. When I insert the coil it shows 0.34, and when I attack the tank it goes down to 0.12, other coils 0.16, and so on...

Hi, I have an iStick Pico. That's as far as my technical knowledge goes. I don't know what coil I have (I always just ask in the shop and show them my vape) but it only ever lasts for about 3 days. Then it starts tasting burnt on and off. I prep it well, soaking the windows and dropping down the...

Hello all, I recently purchased the My Von Erl cigalike and have been really enjoying it's performance and small profile. Its a surprisingly good little unit (imo) but I think it has a little ways to go until it's on the same level as the full blown box mods and tanks I'm used to vaping, but to...

Hello everyone I'm just about over a week into vaping again. A few days ago I was getting hot juice and vapor on my lip and tounge. I made a few adjustments and now I'm not the vapor is fine but I have been feeling like my lips are chapped. So last night my lip was hurting I thought it was a...

So, im new to vaping and i have a general question...does the coil produce harmful smoke? i mean, probably its ok to inhale the smoke which comes from the cotton but what if the coil also produces smoke? i dont want to inhale smoke that comes out from a wire...

I usually vape ejuice with a 60/40 pg/vg ratio and that is fine. However, some juices I purchase burn my throat, even though they have the same ratio. I was wondering what other factors could contribute to this and how I might be able to avoid this problem. This has happened with my Aspire ET-S...

I've been having this ongoing issue where my cotton ALWAYS snaps down the middle after about a day of usage. It never lasts more than a day, and I've been going through cotton like crazy. I'm currently running a 200w Sigelie Fuchai at about 75-80w, on a Velocity Clone RDA, with about 22 gauge...

with your mouth wide open after just filling an RDA. It will result in flying boiling hot liquid onto your tongue leaving you regretting the decision for a good couple days. I seem to never learn my lesson and always seem to get too much juice on the coils by accident.

I recently purchased a cherry bomber box mod (I know it can be dangerous) and i have a RDA that i can fit 3 coils on also I have 2 VCT 5 batterys in the cherry bomber giving me 60 amps. how many ohms do you recommend for a cherry bomber?. as at the moment its really burning my throat and im...

Did anyone see the Inside Edition special on e-cigs exploding? They showed two guys that had their's blow up on them. They only showed a Blu cig and a tube battery. The safety tips were buy real brand products, don't charge with a computer, and few others I don't remember. It was crazy, actually...

so, i have a sigelei 150w with a velocity clone rda. i am building dual parallel 6 wrap coils with 26 guage kanthal A1 (my multimeter reads 0.2 ohms), and some cotton from my local vape shop. my problem is, sometimes i do this build and its vape is as smooth as can be, sometime its the opposite...