Hello, everyone. I hope this is the right thread for this issue.
I'm having an issue with my RDA/coils (will go over my build and what i have tried below) that when I draw for 4+ seconds, I get a bad taste in the cotton.
When reading, note that I have been building for a few years now and have tried most if not all of the newbie stuff.
My coils are well wicked, and well juiced. Is there something different I can try to keep this from happening? I would like to take long draws without the bad taste after 4 seconds.
Here is my build-
Dead Rabbit RDA
Sigeli Kaos Z + Dual VTC5A authentics
Simple Dual 22g 316L SS, 6 wrap, 3mm diameter.
Airflow all the way open, running this .12 ohm build at about 65 watts.
I have tried different wicking methods. Scottish Roll, Dragon, normal wicking, more cotton, less cotton, being careful not to choke it off, ect. And nothing is doing the trick for me.
Will take any suggestions or help I can get.
I'm having an issue with my RDA/coils (will go over my build and what i have tried below) that when I draw for 4+ seconds, I get a bad taste in the cotton.
When reading, note that I have been building for a few years now and have tried most if not all of the newbie stuff.
My coils are well wicked, and well juiced. Is there something different I can try to keep this from happening? I would like to take long draws without the bad taste after 4 seconds.
Here is my build-
Dead Rabbit RDA
Sigeli Kaos Z + Dual VTC5A authentics
Simple Dual 22g 316L SS, 6 wrap, 3mm diameter.
Airflow all the way open, running this .12 ohm build at about 65 watts.
I have tried different wicking methods. Scottish Roll, Dragon, normal wicking, more cotton, less cotton, being careful not to choke it off, ect. And nothing is doing the trick for me.
Will take any suggestions or help I can get.