@Walter Ego
That is one things I like about the cyclone is that fusion drip tip!
I'm liking the fusion drip tip, looks amazing on the standard cap, on the AFC not so much.
Ok I had look up the Reactor and the Odlin BF
Didn't know what they looked like. I like the way the Odlin is except I would want to use some of that nice space for juice so not to squonk as often! Is the hole right thru the center post on that? Is the feed hole above the deck at all? I see it says at deck hieght.
Reactor by Mad Modz bottom fed by chowderhead1972, 15.8 mm dia. three post and the negative posts are milled out of the deck. Great flavor and tons of vapor, the feed/drain hole is in the positive post well and it drains really well.
Odin by Loki Labs has an awesome 2 piece design for single or dual coils. The feed/drain holes feed the two connected wells very nicely and the hole is right at deck level so it drains back very well. The negative screws are on the top of the deck genesis style but have a clever wire capture groove milled into the deck, it is a really easy atty to build on.
I don't get it, for dripping they want the juice well but for BF they want to suck all the juice out? Whats up with that concept that I dont understand? I assume it could be modded some what to leave some juice on the deck? I understand you dont want it to leak but it would be nice to have a little juice, no? Oh well!
It seems to me dripping and squonking are a bit different, when you drip the juice has only one way out, that is through the drip tip in the form of vapor. When you squonk, juice can also go back to the bottle. Every time you heat the coil you heat some juice that doesn't vaporize, cook it a bit, if that juice is in the bottom of the atty it mixes with the fresh juice when you squonk and some goes back into the bottle contaminating the rest of your juice.
Hey what does TRA stand for, tumbled raw alum? You think the circles will help the grip or finger prints at all? I didnt notice before they are circles and spirals aren't they.
Yup Tumbled Raw Aluminium. Help with grip or fingerprints? Nah, they just look hellacool. Just circles, no spirals.
You have a hell of a RDA collection going don't you?
This question made me take an inventory, I have 9 attys for the standard profile and 9 attys for the low profile. The problem is I have 4 standard profile REOs and only 1 LP. Hmmm, I think I need more LP REOs, Rob did say that the mechanical Woodvils would be LP and I'm on the list for a Dibi but that will be a while. Maybe I need to check out colors to see if there are any LPs I can't live without.
This one kind of intrest me. looks like an easy BF conversion. The Veritas 1:1 clone. Everyone on the FT forum is having a fit because of the brass screw is in contact with the juice........I say not an issue. what say you! $8.95 FT diy project.
Looks interesting , let me know how it turns out.
